Single-axis and Two-axis Rotary Indexing Tables with hollow axes

Single-axis or two-axis hollow rotary tables allow the possibility to wire EDM workpieces from the center to the inside diameter of the table. The integrated ring-shaped direct measuring system allows the highest positioning accuracy.

Single-axis and Two-axis rotary indexing tables with hollow spindles

Single-axis Rotary Indexing Table FJRH226R..

FJRH-226R_400DPI

Single-axis rotary indexing table with a hollow Ø 115 mm through hole. In horizontal use, a workpiece with a maximum weight of 65 kg can be machined. In vertical use, a workpiece with a maximum weight of 100 kg can be machined.
Details Type FJRH226R..

Two-axis Rotary Indexing Table FJRTH115R..

FJRTH115R_400DPI

Two-axis rotary indexing table with a hollow Ø 115 mm through hole. Work pieces up to a maximum weight of 25 kg can be machined.
Details Type FJRTH115R..

Two-axis Rotary Indexing Table FJRTH149R..

FJRTH149R_400DPI

Two-axis rotary indexing table with a hollow Ø 149 mm through hole. Work pieces up to a maximum weight of 25 kg can be machined.
Details Type FJRTH-149R..

Rotary Indexing Tables made by Carl Hirschmann

  • Our rotary indexing tables can be used on all EDM, laser, and HSC machines and are completely sealed (IP68) from dielectric fluid (water, oil). The final product details are determined in a consultation with you and/or the machine manufacturer and optimized to your requirements, (with or without clamper, electrical design, etc.). For most new machines, rotary indexing tables are controlled and programmed by the machine control system (A-axis). Older equipment often needs an additional control system for use with the rotary indexing table. Please verify all technical requests in advance with our sales staff or our technical department.
  • On newer machines rotary indexing table can be controlled and programmed by machine control system (A-axis). For use of rotary indexing table on older machines often an additional control system is necessary.

    Please specify technical requirements in advance with our sales and engineering department.
to the top